Table of Contents

Search

  1. Preface
  2. Introduction to Data Transformation
  3. Data Processor Transformation
  4. Wizard Input and Output Formats
  5. Relational Input and Output
  6. Using the IntelliScript Editor
  7. XMap
  8. Libraries
  9. Schema Object
  10. Command Line Interface
  11. Scripts
  12. Parsers
  13. Script Ports
  14. Document Processors
  15. Formats
  16. Data Holders
  17. Anchors
  18. Transformers
  19. Actions
  20. Serializers
  21. Mappers
  22. Locators, Keys, and Indexing
  23. Streamers
  24. Validators, Notifications, and Failure Handling
  25. Validation Rules
  26. Custom Script Components

End of a RepeatingGroup

End of a RepeatingGroup

You can signal the end of a
RepeatingGroup
in ways such as the following:
  • The
    RepeatingGroup
    can continue until the end of the document.
  • You can insert a
    Marker
    after the
    RepeatingGroup
    . By default, the
    Marker
    is in an earlier search phase than the
    RepeatingGroup
    . This causes the Parser to search for the
    Marker
    first and use it to limit the search scope of the
    RepeatingGroup.
    For more information, see Adjusting the Search Phase.
  • You can set the
    count
    property, limiting the search to a maximum number of iterations.
  • If the
    RepeatingGroup
    does not have a
    separator
    , it ends when the Parser cannot find any more iterations.