Table of Contents

Search

  1. Preface
  2. Introduction to Data Transformation
  3. Data Processor Transformation
  4. Wizard Input and Output Formats
  5. Relational Input and Output
  6. Using the IntelliScript Editor
  7. XMap
  8. Libraries
  9. Schema Object
  10. Command Line Interface
  11. Scripts
  12. Parsers
  13. Script Ports
  14. Document Processors
  15. Formats
  16. Data Holders
  17. Anchors
  18. Transformers
  19. Actions
  20. Serializers
  21. Mappers
  22. Locators, Keys, and Indexing
  23. Streamers
  24. Validators, Notifications, and Failure Handling
  25. Validation Rules
  26. Custom Script Components

Data Transformation User Guide

Data Transformation User Guide

Defining a Document Processor

Defining a Document Processor

You can pre-process the source document with any document processor.
  1. Assign the
    example_source
    property of the transformation. The value of the
    example_source
    is an input port, such as
    LocalFile
    or
    Text
    .
  2. Assign the
    pre_processor
    property of the input port.
    The Script applies the processor that you define under
    example_source
    to all sources on which you run the transformation.
You can also define a pre-processor in the
sources_to_extract
property of a Parser. The processor that you define there applies only to the source documents that you define in
sources_to_extract
, and not to any other document that the Parser processes.


Updated September 25, 2018