Table of Contents

Search

  1. Preface
  2. Introduction to Data Transformation
  3. Data Processor Transformation
  4. Wizard Input and Output Formats
  5. Relational Input and Output
  6. XMap
  7. Libraries
  8. Schema Object
  9. Command Line Interface
  10. Scripts
  11. Parsers
  12. Script Ports
  13. Document Processors
  14. Formats
  15. Data Holders
  16. Anchors
  17. Transformers
  18. Actions
  19. Serializers
  20. Mappers
  21. Locators, Keys, and Indexing
  22. Streamers
  23. Validators, Notifications, and Failure Handling
  24. Validation Rules
  25. Custom Script Components

Data Transformation User Guide

Data Transformation User Guide

End of a RepeatingGroup

End of a RepeatingGroup

You can signal the end of a
RepeatingGroup
in ways such as the following:
  • The
    RepeatingGroup
    can continue until the end of the document.
  • You can insert a
    Marker
    after the
    RepeatingGroup
    . By default, the
    Marker
    is in an earlier search phase than the
    RepeatingGroup
    . This causes the Parser to search for the
    Marker
    first and use it to limit the search scope of the
    RepeatingGroup.
    For more information, see Adjusting the Search Phase.
  • You can set the
    count
    property, limiting the search to a maximum number of iterations.
  • If the
    RepeatingGroup
    does not have a
    separator
    , it ends when the Parser cannot find any more iterations.