Table of Contents

Search

  1. Preface
  2. Introduction to Data Transformation
  3. Data Processor Transformation
  4. Wizard Input and Output Formats
  5. Relational Input and Output
  6. XMap
  7. Libraries
  8. Schema Object
  9. Command Line Interface
  10. Scripts
  11. Parsers
  12. Script Ports
  13. Document Processors
  14. Formats
  15. Data Holders
  16. Anchors
  17. Transformers
  18. Actions
  19. Serializers
  20. Mappers
  21. Locators, Keys, and Indexing
  22. Streamers
  23. Validators, Notifications, and Failure Handling
  24. Validation Rules
  25. Custom Script Components

Data Transformation User Guide

Data Transformation User Guide

Correct Solution

Correct Solution

To resolve the ambiguity, you can assign the
target
property of the
RepeatingGroup
.
level 2 RepeatingGroup >> level 3 cleared checkbox skip_failed_iterations level 3 separator_position = after level 3 separator = Marker(NewlineSearch()) level 3 target = level 4 Locator >> level 5 data_holder = /Report/*s/Company level 4 ... level 3 contains line level 3 Content >> level 4 opening_marker = ... level 4 closing_marker = ... level 4 value = LearnByExample("John") level 4 data_holder = /Report/*s/Company/*s/Employee
The
target
identifies the data holder that the
RepeatingGroup
should create. The
target
contains a
Locator
component pointing to the
Company
element. This means that each iteration of the
RepeatingGroup
should create a new occurrence of the
Company
element.
If you configure the
RepeatingGroup
in this way, the output is correct.