Table of Contents

Search

  1. Preface
  2. Introduction to PowerExchange
  3. DBMOVER Configuration File
  4. Netport Jobs
  5. PowerExchange Message Logs and Destination Overrides
  6. SMF Statistics Logging
  7. PowerExchange Security
  8. Secure Sockets Layer Support
  9. PowerExchange Alternative Network Security
  10. PowerExchange Nonrelational SQL
  11. PowerExchange Globalization
  12. Using the PowerExchange ODBC Drivers
  13. PowerExchange Datatypes and Conversion Matrix
  14. DTL__CAPXTIMESTAMP Time Stamps
  15. PowerExchange Glossary

Configuring Statistics Logging to SMF

Configuring Statistics Logging to SMF

To log statistics to SMF, specify the STATS statement with the SMF parameter in the DBMOVER configuration member on z/OS. Then, restart the PowerExchange Listener. By default, PowerExchange does not collect SMF statistics.
To enable PowerExchange to write to SMF, you must also APF-authorize all libraries in the STEPLIB of the PowerExchange Listener JCL.
Use the following syntax for the STATS statement:
STATS=(SMF,
record_number
,{
interval
|
0
})
For example:
STATS=(SMF,255,0)
The following table describes the parameters in the statement:
Parameter
Description
record_number
SMF record number.
Valid values are 128 through 255.
interval
An interval in minutes.
Valid values are 0 and any number from 5 through 120.
Default is 0, which disables interval processing. PowerExchange writes an SMF record when the PowerExchange Listener shuts down.