Resetting the Extraction Start Point for an Application
Resetting the Extraction Start Point for an Application
An application displays the history of change data extractions for a capture registration and stores the start point for the next extraction.
You can reset the start point for the next extraction, displayed as the
Current Run
extraction, to the start point of another extraction.
After you reset the extraction start point, the application can either restart the extraction at the reset start point time, or have its extraction start point reset again. You cannot undo the reset of a start point.
Alternatively, after an initial extraction, you can use the DTLUAPPL utility to reset the extraction start point for an application.
To reset the extraction start point for an application:
Open the application group, and open the application.
The pane on the right side lists the extractions for the application in descending time stamp order.
The information for the current extraction, displayed as the
Current Run
extraction, is blank. All other extractions display a time stamp.
Select the extraction for which to reset the start point.
Right-click the application group name and click
Reset To New Start Point
.
The icon next to the application group name appears in red.
PowerExchange resets the restart point of the next extraction to the start point of the selected extraction.
When you open the application again, the
Current Run
extraction displays the run information from the selected extraction.