Table of Contents

Search

  1. Preface
  2. Introduction to PowerExchange
  3. DBMOVER Configuration File
  4. Netport Jobs
  5. PowerExchange Message Logs and Destination Overrides
  6. SMF Statistics Logging and Reporting
  7. PowerExchange Security
  8. Secure Sockets Layer Support
  9. PowerExchange Alternative Network Security
  10. PowerExchange Nonrelational SQL
  11. PowerExchange Globalization
  12. Using the PowerExchange ODBC Drivers
  13. PowerExchange Datatypes and Conversion Matrix
  14. Appendix A: DTL__CAPXTIMESTAMP Time Stamps
  15. Appendix B: PowerExchange Glossary

Configuring PowerExchange Selective Sign-on

Configuring PowerExchange Selective Sign-on

Configure PowerExchange selective sign-on by completing the following steps.
  1. In the SECURITY statement in the DBMOVER configuration file, set the second parameter to Y.
    The first parameter of the SECURITY statement only controls whether PowerExchange uses the sign-on file to authorize users to issue infacmd pwx commands to a PowerExchange application service in the Informatica domain or pwxcmd commands to a PowerExchange process. The first parameter does not control connections to PowerExchange or access to PowerExchange Listener LISTTASK and STOPTASK commands from the PowerExchange Navigator.
  2. Set up a PowerExchange sign-on file on the Linux, UNIX, or Windows system where the PowerExchange Service or the PowerExchange process runs.
    In the file, specify the allowed users and optionally the IP addresses from which those users are allowed access.
  3. Start or restart the PowerExchange Listener.

0 COMMENTS

We’d like to hear from you!