Table of Contents

Search

  1. Preface
  2. Introduction to PowerExchange
  3. DBMOVER Configuration File
  4. Netport Jobs
  5. PowerExchange Message Logs and Destination Overrides
  6. SMF Statistics Logging and Reporting
  7. PowerExchange Security
  8. Secure Sockets Layer Support
  9. PowerExchange Alternative Network Security
  10. PowerExchange Nonrelational SQL
  11. DTLDESCRIBE Metadata
  12. PowerExchange Globalization
  13. Using the PowerExchange ODBC Drivers
  14. PowerExchange Datatypes and Conversion Matrix
  15. Appendix A: DTL__CAPXTIMESTAMP Time Stamps
  16. Appendix B: PowerExchange Glossary

ADA_L3_ALLOW Statement

ADA_L3_ALLOW Statement

The ADA_L3_ALLOW statement is an Adabas optimization statement that controls whether PowerExchange uses Adabas L3 commands to read records from a file in logical sequence by descriptor value.
z/OS
Adabas
ADAOPT and ADASTATS
No
ADA_L3_ALLOW={
N
|Y}
  • N
    .
    PowerExchange attempts to determine if the Adabas version that is running supports beginning and ending ranges. If PowerExchange determines that the Adabas version supports ranges, PowerExchange uses L3 commands. Otherwise, PowerExchange uses L2 commands.
  • Y.
    If you specify Adabas descriptors on the WHERE clause of an SQL SELECT statement, PowerExchange uses L3 commands to read records in logical order from the Adabas file. If the SQL statement does not contain a WHERE clause, PowerExchange uses L2 commands to read records from the file in the physical order in which Adabas stored them.
    PowerExchange does not verify that the Adabas version in use supports beginning and ending descriptor key ranges with L3 commands.
    Specify Y if PowerExchange cannot correctly determine the running Adabas version.
Default is N.
  • To use L3 commands, you must also specify Y for the ADAOPT statement.
  • Unlike the ADAOPT statement, the ADA_L3_ALLOW statement does not cause PowerExchange to verify that Adabas version 7 or later is running. Use the ADA_L3_ALLOW statement when user modifications to Adabas prevent PowerExchange from verifying which Adabas version is installed.
  • By default, PowerExchange selects
    Ranges Only
    in the
    Optimization Level
    list in data maps. If you select
    OFF
    in the
    Optimization Level
    list, PowerExchange ignores the ADA_L3_ALLOW statement and does not use L3 commands when processing data for that data map.
  • If you specify Y for the ADASTATS statement, PowerExchange writes message PWX-02196 in the PowerExchange message log file. This message indicates whether you can use L3 commands and the status of optimization.

0 COMMENTS

We’d like to hear from you!