Reference Manual

10.5.5
- 10.5.6
- 10.5.4
- 10.5.3
- 10.5.2
- 10.5.1
- 10.5
- 10.4.1
- 10.4.0 HotFix 1
- 10.4.0

Back Next

Configuring PowerExchange Selective Sign-on

Configure PowerExchange selective sign-on by completing the following steps.

In the SECURITY statement in the DBMOVER configuration file, set the second parameter to Y.

The first parameter of the SECURITY statement only controls whether PowerExchange uses the sign-on file to authorize users to issue infacmd pwx commands to a PowerExchange application service in the Informatica domain or pwxcmd commands to a PowerExchange process. The first parameter does not control connections to PowerExchange or access to PowerExchange Listener LISTTASK and STOPTASK commands from the PowerExchange Navigator.

Set up a PowerExchange sign-on file on the Linux, UNIX, or Windows system where the PowerExchange Service or the PowerExchange process runs.

In the file, specify the allowed users and optionally the IP addresses from which those users are allowed access.

Start or restart the PowerExchange Listener.

PowerExchange Selective Sign-on

PowerExchange Sign-on File

Download Guide

Watch

Comments

Communities

Knowledge Base

Success Portal