Preface
Part 1: PowerExchange Change Data Capture Introduction
- Change Data Capture Overview
Part 2: CDC Components Configuration and Management
Part 3: CDC Sources Configuration and Management
Part 4: Change Data Extraction
Part 5: Monitoring and Tuning
Appendix A: CDC for z/OS Troubleshooting
Appendix B: DTL__CAPXTIMESTAMP Time Stamps
- Time Stamps That Are Reported in the DTL__CAPXTIMESTAMP Field by Data Source

CDC Guide for z/OS

10.5
- 10.5.8
- 10.5.6
- 10.5.5
- 10.5.4
- 10.5.3
- 10.5.2
- 10.5.1
- 10.4.1
- 10.4.0 HotFix 1
- 10.4.0

Back Next

COLL_END_LOG Parameter

Controls whether the Adabas ECCR shuts down after a specific number of PLOGs are processed. Used in conjunction with the NO_DATA_WAIT and NO_DATA_WAIT2 parameters.

NO_DATA_WAIT and NO_DATA_WAIT2

COLL_END_LOG={0|number}

0
. The number of PLOGs processed does not affect when the ECCR shuts down.

A number greater than 0. The minimum number of PLOGs that the ECCR must process before it shuts down.

The

z/OS

Installation Assistant enters 1 for this parameter in the ECCR configuration member unless you specify another value. If this parameter is not defined, the default of 0 is used.

Rename Saved Search

Table of Contents

CDC Guide for z/OS

CDC Guide for z/OS

COLL_END_LOG Parameter

COLL_END_LOG Parameter