Table of Contents

Search

  1. Preface
  2. Introduction to Test Data Management
  3. Test Data Manager
  4. Projects
  5. Policies
  6. Data Discovery
  7. Data Subset
  8. Data Masking
  9. Data Masking Techniques and Parameters
  10. Data Generation
  11. Data Generation Techniques and Parameters
  12. Data Sets
  13. Plans and Workflows
  14. Monitor
  15. Reports
  16. ilmcmd
  17. tdwcmd
  18. tdwquery
  19. Data Type Reference
  20. Data Type Reference for Test Data Warehouse
  21. Data Type Reference for Hadoop
  22. Glossary

Available Data Masking Rules

Available Data Masking Rules

The
Data Masking
view lists the rules that you can assign to each column of the data source. You can assign one or more rules for a column if the masking rules are available for the column.
If no rules appear for a column when you click
Masking Rule
, check for the following situations:
  • The project has no rules for the column datatype.
  • The project does not contain policies with masking rules.
  • A data domain that has a preferred rule that you need to use is not in a policy that you assigned to the project.
The PowerCenter Integration Service does not mask integers greater than 28 characters.
If a column has a data domain assignment, the preferred rules for the data domain appear at the top of the list in the
Masking Rule
column. If you forget to add a rule to a data domain, you can assign rules from policy preferred rules. The policy preferred rules appear below the data domain rules in the rules list.
You can apply the default data domain rules to multiple columns at a time. Select multiple columns and click
Rule Assignment
. You can choose to assign the default rules in the
Rule Assignment
dialog box.
In the
Data Masking
view, you must click the
Save
icon after each time you assign a rule. If you do not save the rule assignment before you assign another rule, the Test Data Manager discards the rule assignment.
When you select mapplet rules, advanced rules, or any rule that uses multiple columns, you must configure a mapping between the source ports and the rule ports. The Test Data Manager notifies you when you need to configure the source to rule port mapping.