Specifies the BPEL, WSDL, Schema and other resources used in the test. The resources provide data that creates the set of deployed processes and resources for the Process Server engine. When the B-unit test is started, all of these resources are deployed to the engine much as they would be when the standard engine starts up. The standard static analysis rules for Informatica Business Process Developer are run against each BPEL process identified in the B-unit to ensure that there are no errors in the BPEL or environment.

The Trace option controls console logging output. It is enabled by default and can be useful for tracking down assertion failures if the B-unit view does not provide adequate debugging information.

Extensions specify Logical People Groups that are WS-HT (Human Task) Extensions. Extension Activities specify People activities that are BPEL for People Extension activities.

Specifies invoke activities.

Specifies Wait activities and onAlarm handlers for picks and event handlers. The alarms and invokes elements contain information about each alarm and invoke within the process that is expected to execute during the test. These elements should be thought of as re-active in the sense that they react to the execution of an alarm or invoke within the process. They do not cause an alarm or invoke to execute, but rather wait for the engine to signal that an alarm or invoke has executed and then match that activity within the process to a declaration within the B-unit. Once matched, the B-unit declaration will provide assertions, simulated response/fault/alarm.

Sends messages to the B-unit test engine to execute the test logic. The commands element contains all of the commands that are sent into the engine when the B-unit test executes. These elements should be thought of as active in the sense that they are actions taken by B-unit when it starts the test. Each command is executed in sequence. If the command has an

asynch="true"

attribute then this command is executed on a separate thread. The B-unit test is considered completed when all commands complete. The most common command is the sendMessage command and is the only required command for each B-unit.