Amazon SQS Connector Guide

Amazon SQS Connector Guide

Basic Connection Properties

Basic Connection Properties

The following table describes the basic properties that you can configure on the
Properties
tab of the Connection page:
Property
Description
Name
Required. Unique name for the Amazon SQS connection that identifies it in the Process Designer. The name must start with an alphabet and can contain only alphabets, numbers, and hyphens (-).
Location
Optional. The location of the project or folder where you want to save the connection. Click
Browse
to select a location.
If the
Explore
page is currently active and a project or folder is selected, the default location for the connection is the selected project or folder. Otherwise, the default location is the location of the most recently saved asset.
Description
Optional. Description of the connection.
Type
Required. The type of connection that you want to use for the connector or service connector. Select
Amazon SQS.
Run On
Required. The name of the Secure Agent group or the Secure Agent machine where the connection must run.
Connection Test
Not supported for Amazon SQS Connector.
OData-Enabled
Not supported for Amazon SQS Connector.
After you configure the basic properties, you must also define the following properties:
  • The properties applicable to the Amazon SQS connection type
  • The event source and event target properties for the Amazon SQS connection
After you publish the connection, the
Metadata
tab displays the generated process objects.