Table of Contents


  1. Preface
  2. Introduction to Informatica Cloud MDM - Customer 360 for Salesforce
  3. Configuring the Data Cleansing Settings
  4. Managing Batch Jobs
  5. Verifying Addresses, Email Addresses, and Phone Numbers
  6. Synchronizing Salesforce Records with CC360
  7. Managing Duplicate Records
  8. Consolidating Records
  9. Converting External Records to Salesforce Records
  10. Managing Hierarchies
  11. Integrating Cloud MDM - Customer 360 for Salesforce with Multidomain MDM
  12. Managing Multi-Org
  13. Troubleshooting
  14. Appendix A: Custom Settings
  15. Appendix B: Glossary

Step 2. Configure the Address Verification Service Settings

Step 2. Configure the Address Verification Service Settings

The DaaS job uses the address verification service settings to verify postal addresses.
  1. From the
    section of the
    CC360 Admin
    tab, click
    Run the Setup Wizard
  2. In the
    Service Setup
    section, click
    Address Verification
    Service: Informatica Address Verification
    page appears.
  3. In the
    Service Information
    section, activate the Informatica Address Verification service.
  4. In the
    Informatica Address Verification Configuration
    section, configure the following subsections:
    Enter the authentication credentials to access the address verification service.
    Advanced Settings
    Select one or more of the following options for the point of entry verification:
    • Suggest at the Point of Entry. Suggests the address values when you start entering the address. You must enter at least two address fields to see the suggestions.
      For example, if you enter
      United States
      as the Billing Country and start entering values for the Billing Street, you get suggestions for addresses in
      United States
    • Click to Verify at the Point of Entry. Verifies the complete address that you enter when you click the
      Click to Verify
    • Save to Verify at the Point of Entry. Verifies the address when you click
      in the
      Account Edit
      page or in the record details page.
      When you select the Save to Verify at the Point of Entry option, CC360 does not accept address suggestions and saves the entered values in the address fields with the correct verification status.
    You can also add or remove optional parameters such as Default Country, Minimum Characters for suggestions to appear, and Time Delay for Suggestions to appear (milliseconds).
    Default value for Default Country is United States.
    Service Parameters
    Optional. Add or remove the Use Transaction Pool service parameter.
    You can include the Use Transaction Pool parameter to specify the transaction pool that Informatica DaaS must use for a call.
    For more information about the service parameters, see
    Informatica AddressDoctor® Cloud User Guide
    Validation Parameters
    Add or remove validation parameters to specify which values to validate. By default,
    uses the default values of the parameters.
    If you have state and country picklists enabled in your organization, you must add the Country Type validation parameter and set
    as the value.
    For more information about the validation parameters, see
    Informatica AddressDoctor Cloud User Guide
    Enrichment Parameters
    Optional. Add or remove additional enrichment parameters to use in an address. For example, add
    as the enrichment parameter value to use geocoding details in addresses.
    For more information about the address enrichment, see the
    Informatica Address Verification Developer Guide
  5. Click
  6. To test the connection with the Address Verification service, click
    Test Connection
    Test Connection
    button is enabled only after you save the settings.


We’d like to hear from you!