Table of Contents

Search

  1. Preface
  2. Installation and Configuration
  3. Pre-Installation Tasks
  4. Installation
  5. Post-Installation Tasks
  6. Uninstallation
  7. Troubleshooting the Installation
  8. Configuring Extended JVM Parameters
  9. Glossary

Installation and Configuration Guide

Installation and Configuration Guide

Starting or Stopping the Vibe Data Stream Node on Linux

Starting or Stopping the Vibe Data Stream Node on Linux

To start the
VDS Node
, run the following command from the
<VDS Node installation directory>/node/bin
folder:
./node.sh start <node name>
To stop the
VDS Node
, run the following command:
./node.sh stop <node name>
To start a
VDS Node
installed on a remote machine, run the following command:
./remote-node.sh start <node name>
To stop a
VDS Node
installed on a remote machine, run the following command:
./remote-node.sh stop <node name>
The node name is optional. If you do not specify it, the command uses the host name.