Installation and Configuration Guide

2.3.2
- 2.5.0
- 2.4.0
- 2.3.1
- 2.3.0

Back Next

Generate Keytab Files

If you run the Informatica domain with Kerberos authentication, you must associate Kerberos service principal names (SPN) and keytab files with the nodes and Administrator Daemon. VDS requires keytab files so that services can be authenticated without being prompted for passwords. to generate keytab files, use the SPN and keytab file formats.

The following table describes the SPN format and the keytab file names for the VDS components:

VDS Component	SPN Format	Keytab File Name
Administrator Daemon	admind/<isp domain>@<realm name>	vds_admind.keytab
VDS Node	node/<isp domain>@<realm name>	vds_node.keytab
Adminstrator Tool	_AdminConsole/<isp domain>@<realm name>	_AdminConsole.keytab

To configure Kerberos authentication for VDS, generate keytab files for the Administrator Daemon and the VDS Node. To configure Kerberos authentication between the Administrator Daemon and the Administrator tool, generate keytab files for the Administrator Daemon, the VDS Node, and the Administrator tool.

The keytab files for VDS components must be available on the machines that host the component. During installation, you can specify a directory on the machine to store the keytab files. The installer picks up the keytab files from the keytabs directory you provide during installation.

After installation the Administrator Daemon keytab file is stored in the following directory:

<INFA_HOME>/isp/config/keys

The VDS Node keytab file is stored in the following directory:

<INFA_HOME>/node/config/keys

The Administrator tool keytab file is stored in the following directory:

<INFA_HOME>/isp/config/keys

Prepare for Kerberos Authentication Setup

Download Guide

Watch

Comments

Communities

Knowledge Base