Administrator Guide

Back Next

Windows Command Syntax

On Windows operating systems, the

Data Integration Hub

server utility uses the following syntax:

dihserver 
<start [port]|
 stop [host][port]|
 install|
 svcstart|
 svcstop|
 remove|
 console|
 ping [host][port]|
 status>

The following table describes the

Data Integration Hub

server utility commands:

Command	Description
start	Starts the Data Integration Hub server. You can use the default port number or specify a port number.
stop	Stops the Data Integration Hub server. You can use the default host name and port number or specify a host name and port number.
install	Registers the Data Integration Hub server as a Windows service to the registry.
svcstart	Starts the Data Integration Hub server Windows service.
svcstop	Stops the Data Integration Hub server Windows service.
remove	Removes the Data Integration Hub server Windows service from the Windows registry.
console	Starts the Data Integration Hub server as an application. This command is the same as the Start menu option.
ping	Pings the Data Integration Hub server. You can use the default host name and port number or specify a host name and port number.
status	Returns the status of the Data Integration Hub server Windows service. Returns one of the following values: Not installed Starting Started Stopping Stopped The following example shows the output message that the status command can return: The Data Integration Hub server service is not installed.