Table of Contents

Search

  1. Preface
  2. Introduction to PowerExchange for SAS
  3. Installation and Configuration
  4. Working with SAS Sources
  5. Working with SAS Targets
  6. Working with SAS Sessions
  7. Appendix A: SAS Datatype Reference
  8. Appendix B: SPI Server Configuration Parameters
  9. Appendix C: Error Messages

PowerExchange for SAS User Guide for PowerCenter

PowerExchange for SAS User Guide for PowerCenter

Starting the Communication Component on UNIX

Starting the Communication Component on UNIX

On UNIX, the SPI Server is executable that runs as a daemon process.
You can start and stop the service in the following ways:
  • Go to the directory in which the SPI Server is installed to start and enter the following command:
    spiserver
    Check the SPI Server log file to verify that the server started successfully. You can build an initialization script to start the SPI Server automatically when the system starts.
    If the SPI Server does not shut down normally, it might not restart. If this occurs, remove the SPI Server lock file in the SPI Server working directory and then restart the SPI Server.
  • To stop, enter the following command:
    spiserver stop <host> <portnumber> <administrator name>

0 COMMENTS

We’d like to hear from you!