Administrator Guide

10.4.0
- 10.5
- 10.4.1

Back Next

Operational Data Store Event Loader Configuration

Configure the operational data store event loader variables and parameters to modify certain aspects of the workflow behavior. You can only modify the variables and parameters listed in this section. All other variables and parameters are for internal use.

The following table describes the DX_ETL

and DX_ETL_SQLSERVER

workflow variables and parameters that you can modify:

How to Access	Property	Description
Workflow menu Edit Variables tab	$$WF_Last_Load_End_Time	Last date and time until which the event loader loaded the events to the operational data store. The event loader uses this time as the starting point the next time it loads the events. Default is 01/01/2005 00:00:00.00 Do not modify the variable after the workflow runs. You can modify the variable before the first run.
Workflow menu Edit Variables tab	$$WF_Number_Of_Retry_Attempts	Number of times that the event loader attempts to load the events to the operational data store. If the event loader cannot complete successfully after the defined number of attempts, the workflow fails and creates a Data Integration Hub error event. Default is 3 .
Workflow menu Edit Variables tab	$$WF_Wait_Before_Next_Load_Minutes	Number of minutes to wait before the event loader loads the event to the operational data store. Default is 15 .
WAIT_BEFORE_RETRY task Edit Timer tab	Start_After	Number of minutes to wait before a retry attempt in case of an error in the workflow. Default is 1.

Rename Saved Search

Table of Contents

Administrator Guide

Administrator Guide

Operational Data Store Event Loader Configuration

Operational Data Store Event Loader Configuration