CDC Guide for z/OS

10.4.1
- 10.5.8
- 10.5.6
- 10.5.5
- 10.5.4
- 10.5.3
- 10.5.2
- 10.5.1
- 10.5
- 10.4.0 HotFix 1
- 10.4.0

Back Next

Controlling the Batch VSAM ECCR

You can control the batch VSAM ECCR interface by using PowerExchange Agent commands.

These commands have the following syntax:

cmd_prefix keyword VSAMECCR

Where:

The cmd_prefix variable is the command prefix for the PowerExchange Agent. You specify this prefix in the CmdPrefix statement in the PowerExchange Agent AGENTCTL parameters.

The keyword variable is one of the valid controlling keywords.

The following table describes these keywords:

Keyword	Description
DISPLAY	Displays the number of active and inactive batch VSAM ECCR interface modules that have been loaded on this z/OS system.
START	Activates the Batch VSAM ECCR interface regardless of the value specified in the CCVActive statement in the PowerExchange Agent control parameters (AGENTCTL). Use VSAMECCR/RELOAD to load a new batch VSAM ECCR interface module into Extended Common Storage Area (ECSA). The module is placed at the beginning of the LPA queue in an active state. This command affects all Batch VSAM ECCRs on the same z/OS system.
STOP	Deactivates the Batch VSAM ECCR interface regardless of the value specified in the CCVActive statement in the PowerExchange Agent control parameters (AGENTCTL). To stop capture for a particular VSAM data set, inactivate the capture registration using the PowerExchange Navigator. This command affects all Batch VSAM ECCRs on the same z/OS system.

Rename Saved Search

Table of Contents

CDC Guide for z/OS

CDC Guide for z/OS

Controlling the Batch VSAM ECCR

Controlling the Batch VSAM ECCR