Preface
Part 1: PowerExchange Change Data Capture Introduction
- Change Data Capture Overview
Part 2: CDC Components Configuration and Management
Part 3: CDC Sources Configuration and Management
Part 4: Change Data Extraction
Part 5: Monitoring and Tuning
Appendix A: CDC for z/OS Troubleshooting
Appendix B: DTL__CAPXTIMESTAMP Time Stamps
- Time Stamps That Are Reported in the DTL__CAPXTIMESTAMP Field by Data Source

CDC Guide for z/OS

10.5.6
- 10.5.8
- 10.5.5
- 10.5.4
- 10.5.3
- 10.5.2
- 10.5.1
- 10.5
- 10.4.1
- 10.4.0 HotFix 1
- 10.4.0

Back Next

CLEANUP_INTERVAL Parameter

The number of seconds that the cleanup subtask waits before removing change data from the Datacom CDC tables that has been committed to the PowerExchange Logger logs.

You must also define

CLEANUP=Y

for the cleanup subtask to connect to the Datacom MUF and remove change data from the Datacom CDC tables that has been committed to the PowerExchange Logger logs. The cleanup subtask then waits for the CLEANUP_INTERVAL interval again before doing another cleanup run.

CLEANUP