CDC Guide for z/OS

10.5
- 10.5.8
- 10.5.6
- 10.5.5
- 10.5.4
- 10.5.3
- 10.5.2
- 10.5.1
- 10.4.1
- 10.4.0 HotFix 1
- 10.4.0

Back Next

Post-Log Merge Job Commands

You can issue commands against the Post-Log Merge job to interrogate the status of the Log Reader process, stop the Post-Log Merge job, or instigate traces for problem determination.

The standard format of these commands uses the MVS operator command MODIFY (which can be abbreviated as F) as follows:

MODIFY job_name,DISPLAY
f job_name,DISPLAY

The job_name
is the Post-Log Merge JOB name.

Also, you can use the MVS STOP command (STOP job_name
). It has the same effect as the following MODIFY command:

MODIFYjob_name,QUIT

The following table describes the commands that you can use to manage a Post-Log Merge job:

Command	Description
DISPLAY or DIS	Displays information about Log Reader processes that are connected to the Post-Log Merge task, including what Loggers are being merged, and what the current read location is within each Logger's data. Information is displayed in the Log.
STATUS or STAT	Same as for DISPLAY.
QUIT	Causes Post-Log Merge to terminate. Any active Log Reader processes end abnormally.
STOP	Same as for QUIT.
TRACEE	Disables tracing for the Post-Log Merge task.
TRACES	Activates short-form tracing. No more than 32 bytes of data for each trace entry are produced.
TRACEL	Activates long-form tracing, which causes the entire trace entry to be produced.

Rename Saved Search

Table of Contents

CDC Guide for z/OS

CDC Guide for z/OS

Post-Log Merge Job Commands

Post-Log Merge Job Commands