Table of Contents

Search

  1. Preface
  2. Introduction to Test Data Management
  3. Test Data Manager
  4. Projects
  5. Policies
  6. Data Discovery
  7. Creating a Data Subset
  8. Performing a Data Masking Operation
  9. Data Masking Techniques and Parameters
  10. Data Generation
  11. Data Generation Techniques and Parameters
  12. Working with Test Data Warehouse
  13. Analyzing Test Data with Data Coverage
  14. Plans and Workflows
  15. Monitor
  16. Reports
  17. ilmcmd
  18. tdwcmd
  19. tdwquery
  20. Appendix A: Data Type Reference
  21. Appendix B: Data Type Reference for Test Data Warehouse
  22. Appendix C: Data Type Reference for Hadoop
  23. Appendix D: Glossary

Monitor Tasks

Monitor Tasks

You can perform tasks in the Monitor view based on the job that you view.
You can perform the following tasks in the Monitor view:
Auto Refresh
Refreshes the view every ten seconds. If you disable the auto refresh, click
Actions
Refresh
to manually refresh.
Unschedule
Removes a job that you scheduled to run at a later time. To permanently remove a job from a schedule, click
Actions
Unschedule
.
If you upgrade to TDM 10.2.0, you cannot remove a job that you scheduled in TDM 10.1.0.
Abort
Stops a job immediately. You can abort all jobs except workflows.
Workflow Stop
Stops a workflow after the next commit occurs.
Workflow Abort
Stops a workflow immediately.
Workflow Recover
Recovers an aborted or stopped workflow. If high availability recovery is enabled, the PowerCenter Integration Service restarts the workflow from the last saved checkpoint. Otherwise, the PowerCenter Integration Service clears the state of operation and the recovery information before it restarts the workflow.

0 COMMENTS

We’d like to hear from you!