AWS PrivateLink Onboarding Guide for Informatica Intelligent Cloud Services

AWS PrivateLink Onboarding Guide for Informatica Intelligent Cloud Services

Step 2. Create a VPC endpoint in your Amazon account

Step 2. Create a VPC endpoint in your Amazon account

After Informatica Global Customer Support accepts your request, create a VPC endpoint (VPCE) in your Amazon account.
  1. In the AWS Management Console, under
    Services
    , select
    VPC
    .
  2. Under
    Virtual private cloud
    , click
    Endpoints
    .
  3. On the
    Endpoints
    page, click
    Create endpoint
    .
    The
    Create Endpoint
    page appears:
  4. Under
    Endpoint settings
    , enter a name tag and select the service category
    PrivateLink Ready partner services
    .
  5. Under
    Service settings
    , enter the ARN name provided by Informatica and click
    Verify service
    .
    You should see a message saying that the service name was verified.
    If service verification fails, verify that your VPC endpoint and the AWS PrivateLink account managed by Informatica are in the same region as your
    Informatica Intelligent Cloud Services
    organization. If they're not, you'll need to set up VPC peering to route traffic to an endpoint that is in the same region as the AWS PrivateLink account managed by Informatica. For more information about setting up VPC peering, see the Amazon VPC Peering Guide.
  6. Under
    VPC
    , select the VPC that you want to use to connect to
    Informatica Intelligent Cloud Services
    .
    This is the VPC where your Secure Agents are or will be installed.
  7. Under
    Subnets
    , select the availability zones and subnet IDs that you want to communicate over AWS PrivateLink.
    You can select multiple subnets in different availability zones to ensure that your interface endpoint is resilient to availability zone failures.
  8. For the
    IP address type
    , select
    IPv4
    .
  9. Under
    Security groups
    , select the security groups that define the subnet access.
    Create or select a security group with an inbound rule that allows the following access:
    Property
    Value
    IP version
    IP
    Protocol
    TCP
    Port range
    443
    Source
    The IP address of your subnets
  10. Click
    Create endpoint
    .
  11. Update your support case with Informatica Global Customer Support to let Informatica know that you've completed the endpoint request. Include the VPC endpoint ID in the support the case.
    Informatica Global Customer support will notify you when your request has been accepted. Normally, notification takes two business days or less.

Back to Top

0 COMMENTS

We’d like to hear from you!