Administrator Guide

Back Next

Windows Command Syntax

On Windows operating systems, the

B2B Data Exchange

server utility uses the following syntax:

dxserver 
<start [port]|
 stop [host][port]|
 install|
 svcstart|
 svcstop|
 remove|
 console|
 ping [host][port]|
 pingjms|
 status>

The following table describes the

B2B Data Exchange

server utility commands:

Command	Description
start	Starts the B2B Data Exchange server. You can use the default port number or specify a port number.
stop	Stops the B2B Data Exchange server. You can use the default host name and port number or specify a host name and port number.
install	Registers the B2B Data Exchange server as a Windows service to the registry.
svcstart	Starts the B2B Data Exchange server Windows service.
svcstop	Stops the B2B Data Exchange server Windows service.
remove	Removes the B2B Data Exchange server Windows service from the Windows registry.
console	Starts the B2B Data Exchange server as an application. This command is the same as the Start menu option.
ping	Pings the B2B Data Exchange server. You can use the default host name and port number or specify a host name and port number.
pingjms	Tests all JMS endpoints in the repository and determines whether the B2B Data Exchange server can connect to the JMS service.
status	Returns the status of the B2B Data Exchange server Windows service. Returns one of the following values: Not installed Starting Started Stopping Stopped The following example shows the output message that the status command can return: The B2B Data Exchange server service is not installed.