You can make the Dashboard available in

Data Integration Hub

in two ways. When you install

Data Integration Hub

, you can enable the dashboard that uses operational data store. Otherwise, you can use the dashboard that uses metadata repository which is available by default. This section applies only if you use the Dashboard using operational data store.

Most of the reports in the Dashboard using operational data store are based on key performance indicators (KPIs) that

Data Integration Hub

retrieves from the operational data store, such as events, errors, transactions, and values. The operational data store is a repository that contains aggregated information solely for reporting purposes. The Dashboard retrieves the aggregated events from the operational data store and displays the information in the panels. In addition to the default KPIs, you can select event attributes in the Operation Console to load to the operational data store as custom KPIs.

You use Logi Analytics to create custom reports based on default KPIs or custom KPIs. In Logi Analytics, you set up the custom Dashboard and create custom Dashboard panels that include KPIs based on the information that you want to display. You deploy the custom Dashboard in

Data Integration Hub

and modify the connection properties to retrieve the custom Dashboard panels that you created.

The software available for download at the referenced links belongs to a third party or third parties, not Informatica LLC. The download links are subject to the possibility of errors, omissions or change. Informatica assumes no responsibility for such links and/or such software, disclaims all warranties, either express or implied, including but not limited to, implied warranties of merchantability, fitness for a particular purpose, title and non-infringement, and disclaims all liability relating thereto.

The

Data Integration Hub

administrator installs the operational data store with the main

Data Integration Hub

installation and modifies

Data Integration Hub

system properties to determine certain aspects of the Dashboard behavior, such as whether to show the Dashboard when users log on to the Operation Console and the error rate range in the Error Rate Gauge panel. Operators can personalize the Dashboard page to display different panels and apply filters based on the information that the operators want to view.

After the

Data Integration Hub

administrator installs the Dashboard and Reports component, they use PowerCenter Workflow Manager to configure the operational data store event loader. The operational data store event loader is a PowerCenter workflow that collects KPIs from the

Data Integration Hub

repository according to specified parameters and loads aggregated events to the operational data store. In the operational data store event loader, the

Data Integration Hub

administrator defines parameters such as the number of retry attempts for each event load process in case of failure or the number of minutes to wait between event load processes.