Table of Contents

Search

  1. Preface
  2. Using the Designer
  3. Working with Sources
  4. Working with Flat Files
  5. Working with Targets
  6. Mappings
  7. Mapplets
  8. Mapping Parameters and Variables
  9. Working with User-Defined Functions
  10. Using the Debugger
  11. Viewing Data Lineage
  12. Comparing Objects
  13. Managing Business Components
  14. Creating Cubes and Dimensions
  15. Using the Mapping Wizards
  16. Appendix A: Datatype Reference
  17. Appendix B: Configure the Web Browser

Designer Guide

Designer Guide

Configuring the Debugger

Configuring the Debugger

In addition to setting breakpoints, you must also configure the Debugger. Use the Debugger Wizard in the Mapping Designer to configure the Debugger against a saved mapping. When you configure the Debugger, enter parameters such as the Integration Service, source and target type, and memory parameters. You must enable debugging in the Integration Service configuration before you use it to run the Debugger.
The Debugger Wizard has the following pages:
  1. Introduction.
    This page gives you an overview of the wizard. You do not configure any properties on this page.
  2. Integration Service and session type.
    Choose the Integration Service to run the session. You can also choose to run the Debugger against an existing non-reusable session, an existing reusable session, or create a debug session instance. When you run the Debugger against an existing session, the Integration Service runs the session in debug mode. When you create a debug session, you configure a subset of session properties within the Debugger Wizard, such as source and target location.
  3. Session information.
    If you run the Debugger against an existing session, select the session name. If you create a debug session, configure session parameters.
  4. Session configuration.
    If you create a debug session, set the session configuration.
  5. Target options.
    Choose to load or discard target data.

0 COMMENTS

We’d like to hear from you!