In addition to setting breakpoints, you must also configure the Debugger. Use the Debugger Wizard in the Mapping Designer to configure the Debugger against a saved mapping. When you configure the Debugger, enter parameters such as the Integration Service, source and target type, and memory parameters. You must enable debugging in the Integration Service configuration before you use it to run the Debugger.
The Debugger Wizard has the following pages:
This page gives you an overview of the wizard. You do not configure any properties on this page.
Integration Service and session type.
Choose the Integration Service to run the session. You can also choose to run the Debugger against an existing non-reusable session, an existing reusable session, or create a debug session instance. When you run the Debugger against an existing session, the Integration Service runs the session in debug mode. When you create a debug session, you configure a subset of session properties within the Debugger Wizard, such as source and target location.
If you run the Debugger against an existing session, select the session name. If you create a debug session, configure session parameters.
If you create a debug session, set the session configuration.