CDC Guide for z/OS

10.5.4
- 10.5.8
- 10.5.6
- 10.5.5
- 10.5.3
- 10.5.2
- 10.5.1
- 10.5
- 10.4.1
- 10.4.0 HotFix 1
- 10.4.0

Back Next

NO_DATA_WAIT2 Parameter

After the NO_DATA_WAIT interval is no longer in effect, the number of seconds that the Adabas ECCR waits after processing all PLOG entries in the PCAT file before checking for new PLOG entries to process.

If the COLL_END_LOG parameter is 0 and the NO_DATA_WAIT parameter is greater than 0, the Adabas ECCR retries the NO_DATA_WAIT2 wait and retry cycle on a continuing basis, until the ECCR is shut down or finds new entries in the PCAT.

COLL_END_LOG and NO_DATA_WAIT

NO_DATA_WAIT2={seconds|600}

For the seconds variable, enter a number greater than 0.

The

z/OS

Installation Assistant enters 60 for this parameter in the ECCR configuration member unless you specify another value. If this parameter is not defined, the default of 600 is used.

Configuring the Adabas ECCR Parameters

Download Guide

Watch

Comments

Communities

Knowledge Base

Success Portal