Table of Contents

Search

  1. Preface
  2. Introduction to Dynamic Data Masking
  3. Rules
  4. Connection Rules
  5. Security Rules
  6. Security Rule Set Simulator
  7. Masking Functions
  8. XML Functions Reference
  9. Glossary

Running the Security Rule Set Simulator

Running the Security Rule Set Simulator

You can run the Security Rule Set Simulator on a rule, a rule folder, or a rule set.
Access the Security Rule Set Simulator from the
Action
menu in the Rule Editor. Select
Action
Security Rule Set Simulator
.
Run the Security Rule Set Simulator on the following rule tree nodes:
Rule
To run the simulator on a rule, select the rule in the Rule Editor and open the Security Rule Set Simulator. If you run the simulator on a rule, the simulator tests only the rule, even if the rule uses the Continue processing action.
Rule Folder
To run the simulator on the rules in a rule folder, select the rule folder in the Rule Editor and open the Security Rule Set Simulator. If you run the simulator on a rule folder, the simulator tests all the rules in the folder. Even if the last rule in the folder uses the Continue processing action, the simulator stops at the last rule.
Rule Set
To run the simulator on all the rules in the rule set, select the rule set in the Rule Editor and open the Security Rule Set Simulator. The simulator runs through the rules in the rule set and applies the processing actions.

0 COMMENTS

We’d like to hear from you!