Table of Contents

Search

  1. Preface
  2. Installation and Configuration
  3. Pre-Installation Tasks
  4. Installation
  5. Post-Installation Tasks
  6. Uninstallation
  7. Troubleshooting the Installation
  8. Configuring Extended JVM Parameters
  9. Glossary

Installation and Configuration Guide

Installation and Configuration Guide

Troubleshooting the Installation

Troubleshooting the Installation

When I run the VDS installer, the installer fails to run.
This issue might occur if you do not have permissions for the
/tmp
directory on the hard disk. Ensure that you have permissions for the
/tmp
directory and run the installer again.
The
Administrator Daemon
process stops unexpectedly when I try to start the
Administrator Daemon
.
This error might occur if you change the host name of the machine on which you install the
Administrator Daemon
. After installation, do not change the host name of the machine on which you install the
Administrator Daemon
. If you change the host name, you must reinstall the
Administrator Daemon
.
The
VDS Node
does not start after installation.
This error can occur if you have configured the
VDS Node
incorrectly. Check the
<VDS Installation Directory>/node/logs/<node-name>.out
log file for errors and correct them. Also see the
<VDS Installation Directory>/node/logs/<node name>-node.log
for other errors.
I am not able to see the contents of the
Vibe Data Stream
tab after I create the Vibe Data Stream Service.
This issue can occur if the database user does not have sufficient privileges to create tables in the database. Check the
Administrator Daemon
log files for errors. Perform the following steps to resolve the issue:
  1. Ensure that the database user has sufficient permissions to create tables in the database.
  2. Delete the Vibe Data Stream Service.
  3. Ensure that the
    Administrator Daemon
    is restarted.
  4. Re-create the Vibe Data Stream Service.

0 COMMENTS

We’d like to hear from you!