You can make the Dashboard available in

Data Integration Hub

in two ways. When you install

Data Integration Hub

, you can enable the dashboard that uses operational data store. Otherwise, you can use the dashboard that uses metadata repository which is available by default. All reports on the Dashboard appear in the Events tab. The reports on the Dashboard using the metadata directory are based on information that

Data Integration Hub

collects from the metadata directory.

The reports in the Dashboard

using operational data store

are based on key performance indicators (KPIs) that

Data Integration Hub

retrieves from the operational data store. KPIs provide measurable information about events that

Data Integration Hub

processes. The operational data store is a repository that contains aggregated information solely for reporting purposes.

The Dashboard displays the aggregated event information in panels that you view in the

Dashboard

page of the Operation Console. To use the Dashboard

using operational data store

, you must install and configure the operational data store when you install

Data Integration Hub

.

The following table describes the default KPIs that the Dashboard uses for reports:

KPI	Description
Publication or subscription processing time	Duration in seconds of the time it takes for the publication or subscription to reach a final state.
Number of events	Number of publication and subscription events that Data Integration Hub processes.
Number of error events	Number of error events that reached a final state.

The operational data store event loader is a PowerCenter workflow that collects KPIs from the

Data Integration Hub

repository according to specified parameters and loads aggregated events to the operational data store. You import the workflow to PowerCenter after you install the

Data Integration Hub

Dashboard and Reports component. The workflow runs at scheduled intervals, and you can change certain aspects of the workflow behavior. For example, you can configure the number of retry attempts for each event load process in case of failure or the number of minutes to wait between event load processes.

In Dashboard and reports system properties, you change certain aspects of the Dashboard behavior. For example, you can choose to show the Dashboard

using operational data store

when users log in to the Operation Console.

In the Dashboard using operational data store, you can organize the display of the charts, and add tabs to display selected reports.

Each

report

displays event information from the operational data store or the run-time

Data Integration Hub

repository based on filters that you apply. You can drill to display the events from each panel in the

Event List

page. For more information about specific Dashboard

reports

, see the

Data Integration Hub

Operator Guide

.