Installation for PowerCenter and Data Quality

10.5
- 10.5.6
- 10.5.5.1
- 10.5.5
- 10.5.4
- 10.5.3
- 10.5.2
- 10.5.1
- 10.4.1
- 10.4.0

Back Next

License and Installation Directory

After you verify the installation prerequisites, you can specify the installation directory.

Enter the absolute path for the installation directory.

The directory names in the path must not contain spaces or the following special characters: @|* $ # ! % ( ) { } [ ] , ; '

Default is the user home directory for the user that runs the Informatica installation.

Informatica recommends using alphanumeric characters in the installation directory path. If you use a special character such as á or €, unexpected results might occur at run time.

Choose whether you want to run the installer on a network that uses Kerberos authentication.

Press

to configure the Informatica domain to run on a network that does not use Kerberos authentication.

Press

to configure the Informatica domain to run on a network with Kerberos authentication.

Enter the path and file name of the Informatica license key and press

Enter

Specify the environment type associated with the Informatica services installation.

Press

to set Sandbox environment for a basic environment used for proof of concept with minimal users.

Press

to set Development environment for the design environment.

Press

to set Test environment for high volume processing that is closest to a production environment.

Press

to set Production environment for high volume processing with high levels of concurrency meant for end users. Advanced production environments are typically multi-node setups.

Default is 1 for Sandbox.

If you enabled Kerberos network authentication, the

Service Principal Level

section appears.

If you did not enable Kerberos network authentication, the

Pre-Installation Summary

section appears. Review the installation information and press

Enter

to continue. Skip to Domain Selection.

Join a domain

Download Guide

Watch