//PWXA PROC STARTUP=WARM,HLQ=YOUR.INSTALL.HLQ,
//    RUNLIB=YOUR.INSTALL.HLQ.RUNLIB,
//    LOGGER=PWXL
//* PowerExchange Agent
//*
//* POSSIBLE VALUES FOR STARTUP= ARE WARM AND COLD
//* CAUTION - USE "COLD" START ONLY FOR PROBLEM RESOLUTION
//*
//PWXAGENT EXEC    PGM=EDMSTART,PARM='STARTUP=&STARTUP',
//           TIME=NOLIMIT,
//           ACCT=XXXX
//STEPLIB  DD DISP=SHR,DSN=&HLQ..LOADLIB
//         DD DISP=SHR,DSN=&HLQ..LOAD
//DTLMSG   DD DISP=SHR,DSN=&HLQ..DTLMSG
//DTLCFG   DD DISP=SHR,DSN=&RUNLIB(DBMOVER)
//DTLKEY   DD DISP=SHR,DSN=&RUNLIB(LICENSE)
//EDMPARMS DD DISP=SHR,DSN=&HLQ..&LOGGER..USERLIB
//EDMSCTL  DD DISP=SHR,DSN=&RUNLIB(AGENTCTL),
//            FREE=CLOSE
//* SYSTCPD EXPLICITLY IDENTIFIES WHICH DATA SET IS TO BE USED TO
//*    OBTAIN THE PARAMETERS DEFINED BY TCPIP.DATA. THIS DD STATEMENT
//*    MIGHT BE NECESSARY IF YOUR CONFIGURATION CANNOT BE FOUND USING
//*    USING THE STANDARD IP SEARCH. CONSULT YOUR NETWORKING SYSTEMS
//*    PROGRAMMER FOR FURTHER INFORMATION.
//*SYSTCPD  DD DSN=YOUR.TCPIP.DATA,DISP=SHR
//DTLLOG   DD SYSOUT=*
//DTLLOG01 DD SYSOUT=*
//SYSPRINT DD SYSOUT=*
//*-------------------------------------------------------------------*