Table of Contents

Search

  1. Preface
  2. Introduction to Informatica Cloud MDM - Customer 360 for Salesforce
  3. Configuring the Data Cleansing Settings
  4. Managing Batch Jobs
  5. Verifying Addresses, Email Addresses, and Phone Numbers
  6. Synchronizing Salesforce Records with CC360
  7. Managing Duplicate Records
  8. Consolidating Records
  9. Converting External Records to Salesforce Records
  10. Managing Hierarchies
  11. Integrating Cloud MDM - Customer 360 for Salesforce with Multidomain MDM
  12. Managing Multi-Org
  13. Troubleshooting
  14. Appendix A: Custom Settings
  15. Appendix B: Glossary

Step 4. Configure the Phone Number Validation Service Settings

Step 4. Configure the Phone Number Validation Service Settings

The DaaS job uses the phone validation service settings to validate the phone numbers.
  1. From the
    Setup
    section of the
    CC360 Admin
    tab, click
    Run the Setup Wizard
    .
  2. In the
    Service Setup
    section, click
    Phone Number Validation
    .
    The
    Service : Informatica Phone Number Validation
    page appears.
  3. In the
    Service Information
    section, activate Informatica Phone Verification service.
  4. In the
    Informatica Phone Number Validation Configuration
    section, configure the following subsections:
    Authentication
    Enter the authentication credentials to access the phone number validation service.
    Advanced Settings
    Configure the following parameters:
    • Click to Verify at the Point of Entry
      . Verifies the phone number at the point of entry.
    • Save to Verify at the Point of Entry
      . Verifies the phone number when you save.
    • Phone Validation Version
      . Specifies the version of the DaaS service that you want to use for phone number verifications.
    You can also add optional parameters, such as Default Country Code. The default country code is +1.
    If you do not add the country code when you enter a phone number, the phone number validation service adds the default country code to the phone number.
  5. Click
    Save
    .
  6. To test the connection with the Phone Number Validation service, click
    Test Connection
    .
    The
    Test Connection
    button is enabled only after you save the settings.

0 COMMENTS

We’d like to hear from you!