Table of Contents

Search

  1. Preface
  2. Introduction to Informatica MDM - Supplier 360
  3. Supplier 360 Installation Overview
  4. Before You Install
  5. Install the Application
  6. After You Install
  7. Business Processes for Supplier Management
  8. Customize the Application
  9. Troubleshooting
  10. MDM - Supplier 360 Upgrade

Installation Topology

Installation Topology

You can use
Supplier 360
application with or without MDM - Product 360.
Based on your requirements, use one of the following installation topologies:
With Product 360
Supplier 360 is integrated with Product 360. In this mode, the Supplier portal uses the following Product 360 services:
  • Timeline that shows updates from Product 360
  • Product catalog management
  • User authentication and user management
Without Product 360
Supplier 360 is integrated with an external user management system or an external product information management system. You can use the external user management system or the product information management system to handle the user authentication and user management.
If you use an external user management system, configure an external custom adapter to manage user, and build email templates for ActiveVOS to handle user invitations and password resets. For more information about configuring a custom adapter, contact your Informatica representative.
Standalone Mode
Supplier 360 is not integrated with Product 360 or any other products. Supplier 360 uses Multidomain MDM for user authentication and user management.

0 COMMENTS

We’d like to hear from you!