- Data Engineering Integration 10.5
- All Products
Blaze Staging Directory
The HDFS file path of the directory that the Blaze engine uses to store temporary files. Verify that the directory exists. The YARN user, Blaze engine user, and mapping impersonation user must have write permission on this directory.
/blaze/workdir. If you clear this property, the staging files are written to the Hadoop staging directory
Blaze User Name
The owner of the Blaze service and Blaze service logs.
When the Hadoop cluster uses Kerberos authentication, the default user is the Data Integration Service SPN user. When the Hadoop cluster does not use Kerberos authentication and the Blaze user is not configured, the default user is the Data Integration Service user.
The minimum value for the port number range for the Blaze engine. Default is 12300.
The maximum value for the port number range for the Blaze engine. Default is 12600.
YARN Queue Name
The YARN scheduler queue name used by the Blaze engine that specifies available resources on a cluster.
If YARN preemption is enabled on the cluster, verify with the Hadoop administrator that preemption is disabled on the queue associated with the Blaze engine.
Blaze Job Monitor Address
The host name and port number for the Blaze Job Monitor.
Use the following format:
For example, enter:
Blaze YARN Node Label
Node label that determines the node on the Hadoop cluster where the Blaze engine runs. If you do not specify a node label, the Blaze engine runs on the nodes in the default partition.
If the Hadoop cluster supports logical operators for node labels, you can specify a list of node labels. To list the node labels, use the operators
You cannot use node labels on a Cloudera CDH cluster.
List of advanced properties that are unique to the Blaze engine. The advanced properties include a list of default properties.
You can configure run-time properties for the Hadoop environment in the Data Integration Service, the Hadoop connection, and in the mapping. You can override a property configured at a high level by setting the value at a lower level. For example, if you configure a property in the Data Integration Service custom properties, you can override it in the Hadoop connection or in the mapping. The Data Integration Service processes property overrides based on the following priorities:
Informatica does not recommend changing these property values before you consult with third-party documentation, Informatica documentation, or Informatica Global Customer Support. If you change a value without knowledge of the property, you might experience performance degradation or other unexpected results.
Updated February 28, 2022