Setting Advanced Parameters for the InitialSync, Extractor, and Applier Tasks
Setting Advanced Parameters for the InitialSync, Extractor, and Applier Tasks
On the
Runtime Settings
tab >
Advanced Settings
view, you can specify runtime parameters for the InitialSync, Extractor, and Applier programs.
Data Replication supplies default values for most of the parameters listed in the Console and in the AdvancedParameters.xml file in the
DataReplication_installation
/uiconf directory. If you edit the default values or add values for the few parameters that do not have defaults, the updated parameter values are included in the configuration. Also, you might need to add user-defined parameters at the direction of Informatica Global Customer Support.
This view lists the runtime parameters that are applicable to the source and target that are defined for the replication job, including the default parameter values. The parameters are grouped by component or parameter type and listed under each group in alphabetical order.
The following image shows the
Advanced Settings
view:
To edit a listed parameter value, perform the following substeps:
Select the parameter and click
Edit
.
In the
Input
dialog box, enter a new value and click
OK
.
Data Replication validates the value against the AdvancedParameters.xml file. Data Replication checks that the value is within the minimum and maximum range of values, if applicable, and is consistent with the data type.
To reset a listed parameter to its default value, select the parameter and click
Reset
.
The
Reset
button does not affect any user-defined parameters.
If you need to add a user-defined parameter at the direction of Informatica Global Customer Support, perform the following substeps:
Click
New
.
Enter the parameter name that Support supplies and click
OK
.
Enter the parameter value and click
OK
.
The new parameter appears under the
User Defined
section.
To delete a user-defined parameter, select the parameter and click