Table of Contents

Search

  1. Preface
  2. Installation Overview
  3. Installing Identity Resolution
  4. Post-Installation Tasks
  5. Troubleshooting
  6. Upgrading Identity Resolution
  7. Uninstalling Identity Resolution

Installation and Configuration Guide

Installation and Configuration Guide

Configuring IBM DB2 on z/OS

Configuring IBM DB2 on z/OS

You can use IBM DB2 on z/OS as a source database for
Identity Resolution
.
To configure IBM DB2 on z/OS, perform the following tasks:
  1. Request the
    ssa.xmit.ids910.ssaudf
    data set file from Informatica Global Customer Support.
    This file is not part of the installation files, so you must request it from the Global Customer Support.
  2. By using a FTP client in binary mode, transfer the data set file to your mainframe system.
    For example:
    ftp> quote site lrecl=80 recfm=fb blksize=3120 vol=ssawrk cylinders ftp> bin ftp> put ssa.xmit.ids910.ssaudf ’ssa.xmit.ids910.ssaudf’
    If you use the z/OS FTP client, use the LOCSIte command instead of the QUOte command.
  3. Unpack the
    ssa.xmit.ids910.ssaudf
    file by using one of the following methods:
    • Run the following command from the shell:
      receive indsn(’ssa.xmit.ids910.ssaudf’) da(’ssaudf.load’)
    • Run the following command from JCL by invoking the
      IKJEFT1A
      TSO interpreter:
      //SSAINS JOB (1),IEBCOPY,NOTIFY=&SYSUID //STEP1 EXEC PGM=IKJEFT1A //SYSTSPRT DD SYSOUT=* //SYSTSIN DD * RECEIVE INDSN(’SSA.XMIT.IDS910.SSAUDF’) DA(’SSAUDF.LOADD’) VOLUME(SSA001) /* //*
  4. Copy the
    SSAUDF
    and
    II4TOUL
    data set members to the
    DB2HLQ.RUNLIB.LOAD
    load library.