Administrator Guide

Back Next

Step 3. Configure the Email Address Verification Service Settings

The DaaS batch job uses the email address verification service settings to verify email addresses.

From the

Setup

section of the

CC360 Admin

tab, click

Run the Setup Wizard

In the

Service Setup

section, click

Email Verification

The

Service : Informatica Email Verification

page appears.

In the

Service Information

section, activate Informatica Email Verification service.

In the

Informatica Email Verification Configuration

section, configure the following subsections:

Authentication: Enter the authentication credentials to access the email verification service.
Advanced Settings: Select one or more of the following options for the point of entry verification:
Enable Point of Entry Click to Verify. Verifies the email address at the point of entry.
Enable Point of Entry Save to Verify. Verifies the email address when you save a record.
Additional Parameters: Optional. Enter a value for
Timeout (seconds)
. Timeout is the total number of seconds that the service runs to verify the email address. The verification request fails after the specified time period. Default is 90 seconds.; You can also add or remove optional parameters, such as Optional Source ID.

Click

Save

To test the connection with the Email Address Verification service, click

Test Connection

The

Test Connection

button is enabled only after you save the settings.

If the test connection is successful, you also see the number of remaining hits available for the configured license key.