Table of Contents

Search

  1. Preface
  2. Introduction to Informatica Cloud MDM - Customer 360 for Salesforce
  3. Configuring the Data Cleansing Settings
  4. Managing Batch Jobs
  5. Verifying Addresses, Email Addresses, and Phone Numbers
  6. Synchronizing Salesforce Records with CC360
  7. Managing Duplicate Records
  8. Consolidating Records
  9. Converting External Records to Salesforce Records
  10. Managing Hierarchies
  11. Integrating Cloud MDM - Customer 360 for Salesforce with Multidomain MDM
  12. Managing Multi-Org
  13. Custom Settings
  14. Glossary

Step 3. Configure the Email Address Verification Service Settings

The DaaS batch job uses the email address verification service settings to verify email addresses.
  1. From the
    Setup
    section of the
    CC360 Admin
    tab, click
    Run the Setup Wizard
    .
  2. In the
    Service Setup
    section, click
    Email Verification
    .
    The
    Service : Informatica Email Verification
    page appears.
  3. In the
    Service Information
    section, activate Informatica Email Verification service.
  4. In the
    Informatica Email Verification Configuration
    section, configure the following subsections:
    Authentication
    Enter the authentication credentials to access the email verification service.
    Advanced Settings
    Select one or more of the following options for the point of entry verification:
    • Enable Point of Entry Click to Verify. Verifies the email address at the point of entry.
    • Enable Point of Entry Save to Verify. Verifies the email address when you save a record.
    Additional Parameters
    Optional. Enter a value for
    Timeout (seconds)
    . Timeout is the total number of seconds that the service runs to verify the email address. The verification request fails after the specified time period. Default is 90 seconds.
    You can also add or remove optional parameters, such as Optional Source ID.
  5. Click
    Save
    .
  6. To test the connection with the Email Address Verification service, click
    Test Connection
    .
    The
    Test Connection
    button is enabled only after you save the settings.

0 COMMENTS

We’d like to hear from you!