Administrator Guide

Back Next

Step 3. Configure the Email Address Verification Service Settings

The DaaS batch job uses the email address verification service settings to verify email addresses.

Based on the Salesforce environment that you use, perform one of the following tasks:

In Salesforce Classic, from the

Setup

section of the

CC360 Admin

tab, click

Run the Setup Wizard

In Lightning Experience, perform the following tasks:

On the navigation menu, click

CC360 Admin

The

Manage CC360

page appears.

From the

Setup

section, click

Run the Setup Wizard

In the

Service Setup

section, click

Email Verification

The

Service : Informatica Email Verification

page appears.

In the

Service Information

section, activate Informatica Email Verification service.

In the

Informatica Email Verification Configuration

section, configure the following subsections:

Authentication: Enter the authentication credentials to access the email verification service.
Advanced Settings: Select one or more of the following options for the point of entry verification:
Enable Point of Entry Click to Verify. Verifies the email address at the point of entry.
Enable Point of Entry Save to Verify. Verifies the email address when you save a record.
Additional Parameters: Optional. Enter a value for
Timeout (seconds)
. Timeout is the total number of seconds that the service runs to verify the email address. The verification request fails after the specified time period. Default is 90 seconds.; You can also add or remove optional parameters, such as Optional Source ID.