Table of Contents


  1. Preface
  2. Introduction to Informatica Customer 360 for Salesforce
  3. Configuring the Data Cleansing Settings
  4. Managing Batch Jobs
  5. Verifying Addresses, Email Addresses, and Phone Numbers
  6. Synchronizing Salesforce Records with Customer 360 for Salesforce
  7. Managing Duplicate Records
  8. Consolidating Records
  9. Converting External Records to Salesforce Records
  10. Managing Hierarchies
  11. Integrating Customer 360 for Salesforce with Multidomain MDM
  12. Managing Multi-Org
  13. Troubleshooting
  14. Appendix A: Custom Settings
  15. Appendix B: Glossary

Step 3. Configure the Email Address Verification Service Settings

Step 3. Configure the Email Address Verification Service Settings

The DaaS batch job uses the email address verification service settings to verify email addresses.
  1. From the
    section of the
    CC360 Admin
    tab, click
    Run the Setup Wizard
  2. In the
    Service Setup
    section, click
    Email Verification
    Service : Informatica Email Verification
    page appears.
  3. In the
    Service Information
    section, activate Informatica Email Verification service.
  4. In the
    Informatica Email Verification Configuration
    section, configure the following subsections:
    Connection and Authentication
    Enter the following parameters:
    • User Id/License Key and Password. Authentication credentials to access the Email Verification service.
    • Email Validation Version. Version of the DaaS service that you want to use to verify email addresses.
    • Webservice Endpoint. An endpoint URL to process the Email Verification service. CC360 locates the web service that the endpoints identify in the United States and the European Union. You can select one of the following endpoints:
      • US
      • EU
      Default is US.
    Advanced Settings
    Select one or more of the following options for the point of entry verification:
    • Click to Verify at the Point of Entry. Verifies the email address at the point of entry.
    • Save to Verify at the Point of Entry. Verifies the email address when you save a record.
    Additional Parameters
    Optional. Enter a value for
    Timeout (seconds)
    . Timeout is the total number of seconds that the service runs to verify the email address. The verification request fails after the specified time period. Default is 90 seconds.
    You can add or remove optional parameters, such as
    Optional Source ID
    Email 7 Max Suggestions (0-10)
    , and
    Email 7 Risk Profile
  5. Click
  6. To verify the connectivity to the Email Verification service, click
    Service Information
    Test Connection
    You can test the connection only after you save the settings.
    If the test connection is successful, you can see the number of remaining hits available for the configured license key.


We’d like to hear from you!