Installation and Upgrade Guide

10.5.8
- 10.5.6
- 10.5.5
- 10.5.4
- 10.5.3
- 10.5.2
- 10.5.1
- 10.5
- 10.4.1
- 10.4.0 HotFix 1
- 10.4.0

Back Next

After You Install PowerExchange on IBM i

After you install PowerExchange, perform the following post-installation tasks:

If you are upgrading from a previous release, review the

PowerExchange Release Guide

for new features and changes.

Optionally, copy PowerExchange data and configuration files from the previous release.

Configure PowerExchange prior to performing bulk data movement or change data capture (CDC).

For more information about configuring PowerExchange, see the following documents:

For bulk data movement configuration, see the

PowerExchange Bulk Data Movement Guide

For CDC configuration, see the

PowerExchange CDC Guide for i5/OS

For DBMOVER configuration file parameters, see the

PowerExchange Reference Manual

After you have configured PowerExchange and optionally copied PowerExchange data, you can start the PowerExchange Listener and, if required, PowerExchange Condense. For more information about starting and stopping PowerExchange tasks, see the

PowerExchange Command Reference

Performing a Full Installation on IBM i

Download Guide

Watch

Comments

Communities

Knowledge Base

Success Portal

0 COMMENTS

We’d like to hear from you! Log in to comment.

Rename Saved Search

Table of Contents

Installation and Upgrade Guide

Installation and Upgrade Guide

After You Install PowerExchange on IBM i

After You Install PowerExchange on IBM i