Table of Contents


  1. Preface
  2. Introduction to Data Transformation
  3. Data Processor Transformation
  4. Wizard Input and Output Formats
  5. Relational Input and Output
  6. Using the IntelliScript Editor
  7. XMap
  8. Libraries
  9. Schema Object
  10. Command Line Interface
  11. Scripts
  12. Parsers
  13. Script Ports
  14. Document Processors
  15. Formats
  16. Data Holders
  17. Anchors
  18. Transformers
  19. Actions
  20. Serializers
  21. Mappers
  22. Locators, Keys, and Indexing
  23. Streamers
  24. Validators, Notifications, and Failure Handling
  25. Validation Rules
  26. Custom Script Components

Configuring the First Table

Configuring the First Table

  1. Configure a Parser and assign the PDF document as the
    . Double-click on the
    property to open the table configuration editor.
  2. In the PDF display, browse to the first table.
  3. Set Table Start = GID RMS ID, the headings of the first two columns of the table. Note that the expression is case sensitive.
  4. Set Table End = Forward exchange transactions, the first text following the table. The editor displays the table configuration.
  5. If necessary, adjust the table definition and the columns. You can drag, add, or remove column borders.

Updated March 03, 2021