Table of Contents


  1. Preface
  2. Introduction to Data Transformation
  3. Data Processor Transformation
  4. Wizard Input and Output Formats
  5. Relational Input and Output
  6. Using the IntelliScript Editor
  7. XMap
  8. Libraries
  9. Schema Object
  10. Command Line Interface
  11. Scripts
  12. Parsers
  13. Script Ports
  14. Document Processors
  15. Formats
  16. Data Holders
  17. Anchors
  18. Transformers
  19. Actions
  20. Serializers
  21. Mappers
  22. Locators, Keys, and Indexing
  23. Streamers
  24. Validators, Notifications, and Failure Handling
  25. Validation Rules
  26. Custom Script Components

Components Nested within a Mapper

Components Nested within a Mapper

Within a
, you can nest the following components:
  • Any number of
    actions. The actions retrieve a data holder from the output and write the content to the output.
  • Optionally, any number of Mapper anchors. For more information, see the Mapper Anchor Component Reference.
  • Optionally, any number of additional actions.
actions and the Mapper anchors can be in any sequence. You can also insert other actions in the sequence.
Notice that a Mapper uses
actions rather than Mapper anchors to write to the output XML. This may seem a little different from Parsers and Serializers, where the output is created by anchors and serialization anchors, respectively. Actually, this is just a terminology issue. The
action could have been defined as a Mapper anchor. It is defined as an action because it is useful in other circumstances, unrelated to Mappers.

Updated March 03, 2021