When you deploy a mapping that includes an in-out parameter, the task sets the parameter value at run time based on the parameter's retention policy. By default, the

mapping

task retains the value set during the last session. If needed, you can reset the value in the

mapping

task.

From the

mapping

task wizard, you can perform the following actions for in-out parameters:

View the values of all in-out parameters in the mapping, which can change each time the task runs.
Reset the configuration to the default values. Click
Refresh
to reset a single parameter. Click
Refresh All
to reset all the parameters.
Edit or change specific configuration details. Click
Edit
.

For example, the following image shows configuration details of the "Timestamp" parameter and the value at the end of the last session:

To find the value of an in-out parameter after a task runs, view the job details. To view job details, open

Monitor

and select

All Jobs

or open

Data Integration

and select

My Jobs

. Then click the job name.

The following image shows an example of the available details, including the current value of the specified parameter, set during the last run of a

mapping

task:

The in-out parameters appear in the job details based on the retention policy that you set for each parameter.