Administrator Guide

Winter 2019

Back Next

Step 2. Configure the Address Verification Service Settings

The DaaS job uses the address verification service settings to verify postal addresses.

From the

Setup

section of the

CC360 Admin

tab, click

Run the Setup Wizard

In the

Service Setup

section, click

Address Verification

The

Service: Informatica Address Verification

page appears.

In the

Service Information

section, activate the Informatica Address Verification service.

In the

Informatica Address Verification Configuration

section, configure the following subsections:

Authentication: Enter the authentication credentials to access the address verification service.
Advanced Settings: Select one or more of the following options for the point of entry verification:
Enable Point of Entry Suggestions. Suggests the address values when you start entering the address. You must enter at least two address fields to see the suggestions.
For example, if you enter
United States
as the Billing Country and start entering values for the Billing Street, you get suggestions for addresses in
United States
.
Enable Point of Entry Click to Verify. Verifies the complete address that you enter when you click the
Click to Verify
button.
Enable Point of Entry Save to Verify. Verifies the address when you click
Save
in the
Account Edit
page or in the record details page.
When you select the Enable Point of Entry Save to Verify option, CC360 does not accept address suggestions and saves the entered values in the address fields with the correct verification status.; You can also add or remove optional parameters such as Default Country, Minimum Characters for suggestions to appear, and Time Delay for Suggestions to appear (milliseconds).
Default value for Default Country is United States.
Service Parameters: Optional. Add or remove the Use Transaction Pool service parameter.; You can include the Use Transaction Pool parameter to specify the transaction pool that Informatica DaaS must use for a call.; For more information about the service parameters, see
Informatica AddressDoctor® Cloud User Guide
.
Validation Parameters: Add or remove validation parameters to specify which values to validate. By default,
CC360
uses the default values of the parameters.
If you have state and country picklists enabled in your organization, you must add the Country Type validation parameter and set
ISO2
as the value.; For more information about the validation parameters, see
Informatica AddressDoctor Cloud User Guide
.
Enrichment Parameters: Optional. Add or remove the enrichment parameters to receive additional information for an address.; For more information about the enrichment parameters, see
Informatica AddressDoctor Cloud User Guide
.