Table of Contents


  1. Preface
  2. Introduction to Data Transformation
  3. Data Processor Transformation
  4. Wizard Input and Output Formats
  5. Relational Input and Output
  6. Using the IntelliScript Editor
  7. XMap
  8. Libraries
  9. Schema Object
  10. Command Line Interface
  11. Scripts
  12. Parsers
  13. Script Ports
  14. Document Processors
  15. Formats
  16. Data Holders
  17. Anchors
  18. Transformers
  19. Actions
  20. Serializers
  21. Mappers
  22. Locators, Keys, and Indexing
  23. Streamers
  24. Validators, Notifications, and Failure Handling
  25. Validation Rules
  26. Custom Script Components

Initializing Variables at Runtime

Initializing Variables at Runtime

You can initialize the values of variables in the following ways:
  • In the Script, you can configure the
    property of the
    The initial values that you set by this approach are used when you run the transformation in the Developer tool or as a service.
  • An application can pass the initial values as service parameters to a service at runtime.
    The service parameters override the
    property of the variables. If the Script specifies an initial value, and you also pass a value from an application, the latter value is used.

Updated March 18, 2021