Assign each job to a group. A group is a set of jobs that run concurrently. Groups run sequentially, and all jobs in the previous group complete before the next group begins. You might set up groups when data in one group depends on the results of a previous group. There is no limit on the number of jobs and groups that you can add to a dynamic mapping task.

The following image shows the

Jobs

page:

Add a job
Select parameter value
Parameter settings
Add a job to a group
Enable/Disable job
Add a group

When you add a job,

Data Integration

displays each parameter in the mapping. If a parameter has default scope,

Data Integration

automatically applies the default value to the job. You can edit the parameter value and parameter settings for each job.

By default,

Data Integration

enables a job or group when you add it. You can disable individual jobs so that they won't run when you run the task. If you disable a group, no jobs in that group run when you run the task.